4400x floor standing water cooler
New HygieneGuard Tap Cover
The most critical hygiene area is undoubtedly the tap, which often
gets contaminated through user hand contact (by comparison the
“waterside” is much less critical). A silver impregnated plastic tap
cover is designed to stop bacterial growth from contact
contamination.The HygieneGuard tap cover can easily be replaced.
Cabinet
Cold-rolled 20 gauge embossed steel with baked on acrylic
enamel finish
Drip tray
Lift out design which can be connected to mains drainage, High
impact durable plastic. Removable anti splash grid
Taps
Modern push and hold solenoid taps replace the old fashioned
manual taps.The push and hold action prevents leaving the tap
running by mistake whilst operating as a safety tap mechanism at
the same time.The spouts of the solenoid taps are protected by
the new HygieneGuard tap covers.Their silver impregnation is
designed to prevent hand to tap bacterial contamination
Cup Holder
Integrated cup holder with exposed locking nuts to open up for
easy refilling of cups
Removable Lower Front Panel
Spring loaded lower front panel. Remove drip tray and simply
press down to remove entire lower front panel for easy access
Filters
POU Coolers are often fitted with a 1 micron nominal size
Carbon Block Filter which removes the taste and smell of
chlorine, a host of heavy metals/ chemicals and some pathogens
which are unable to pass through the 1 micron nominal Carbon
Block pore size
The AASIP4400X model
This model comes with SIP Ozonation which automatically
sanitises the Cooler for 5 minutes at 2am every 24 hours trough
a burst of Ozone into the water tank and system. SIP Ozonation
has been thoroughly tested and it has been accepted that it
reduces the need for hard sanitisation of Coolers by half (POU
Coolers from 2 x to 1 x per year and Bottled Coolers from 4 x
to 2 x per year). SIP Ozonation represents a significant advance
over UV and other sanitising methods
Refrigeration system
Quiet, air cooled static-type condenser. No fan required.
Protected against motor overload.
Cooling System
Stainless Steel 3 litre cold water tank.Thermostatically controlled
to 4C - 12C
Heating System
Stainless Steel 2 litre tank.Thermostatically controlled to between
87 and 92ºC.
Designed to prevent total drainage for heating element protection.
Easily accessible hot water tank drain at the back of the Cooler
Power supply
220 Volt, 50/60 Hz. Provided with a 3 pin plug and 180 cm
power cord
Dimensions
Floor standing:
Height 1135mm
Width 340mm
Depth 340mm
Shipping weights
Floor Standing: 18kg
Table Top: 15kg
